ST Modular Cause & Effect 1U

10,95 €

inkl. MwSt. zzgl. Versand

Beschreibung

Cause & Effect

1U 20HP Utility Tool


Cause & Effect is a utility tool for audio and CV consisting of three interconnected units.


The first unit is a VOLTAGE READER that outputs a gate signal according to a limit set with the help of the READ LIMIT

potentiometer. If the limit set is reached by the incoming voltage, the R GATE output will be high. The limit may also

be controlled via external control voltage at the LIMIT CV jack.

Any voltage voltage applied to READ IN is normalised to HOLD IN and IN A.

R GATE is normalized to H GATE and SW GATE. This way only one signal is necessary to control both other units.


The second unit is called HOLD. In one mode it can sample and store a voltage from the HOLD IN jack and supply

it at the HOLD OUT jack, if gate at H GATE is high. In another mode it can pass through the incoming voltage when

gate is high. It then samples and stores the last voltage value applied when gate switches to low. The modes are

selectable via the HOLD MODE switch.


The third unit is a GATE SWITCH. If a gate signal is applied to the SW GATE input only IN B will be connected to the

A or B output jack. If gate is low IN A is available at the output. IN A is inverted and normalized to IN B.


Details:

• Three Utility Tool

• Voltage reader for gates

• Hold for sampled voltages

• Gate switch for selectable voltages

• Two hold modes

• Inputs normalized

• Available in Intellijel and Pulp Logic Tile format

• Skiff friendly

• 1U Eurorack module, 20 HP wide

• Power consumption: 35 mA at +12 V and 31 mA at -12V


The module consists of two boards:

• Front PCB Panel

• Main PCB